Specifications

36 Error Messages Displayed When Editing the Configuration
656
Message Description
Cannot attach this list because flow
detection mode Layer2-1.
If the flow detection mode is Layer 2-1, this QoS flow list cannot be
applied.
If the flow detection mode is Layer 2-1, a MAC QoS flow list can be
applied.
To do so, you can use the following command:
mac qos-flow-group command
Cannot attach this list because flow
detection mode Layer2-2.
If the flow detection mode is Layer 2-2, this QoS flow list cannot be
applied.
If the flow detection mode is Layer 2-2, an IPv4 QoS flow list can be
applied.
To do so, you can use the following command:
ip qos-flow-group command
Maximum number of entries are already
defined. <value1>
You are trying to add more than the allowable maximum number of
entries. Delete entries that are no longer needed, and then add the
entries.
Over two entry as an address family
cannot be set.
Another QoS flow list has already been applied.
If you want to apply a QoS flow list, first delete the existing QoS flow
list that has already been applied.
system function isn't set. The setting is not possible because the system function
command has not been set.
Use the system function command to specify qos.
The different name is already defined. An entry cannot be added to an interface for which queue-group
has already been set.
The Maximum number of entries are
already defined. <QOSFLOW_GROUP>
The maximum number of QoS flow lists that can be applied to an
interface has been exceeded.
The Maximum number of entries are
already defined. <QOSFLOW_LIST>
The maximum number of QoS flow list remark settings has been
exceeded.
The Maximum number of entries are
already defined. <QOSFLOW_MAC>
The number of entries for a MAC-QoS flow list exceeds the capacity
limit.
The maximum number of entries are
exceeded.
The number of QoS entries exceeds the capacity limit.
The number of used entries and available entries in the configuration
can be checked by using the show system command.
The sequence number exceeded the
maximum value. Try "resequence"
Command.
The automatic sequence number has exceeded the maximum value.
Execute the resequence command.
The total of min-rate exceeded
bandwidth of port.
The total of the specified minimum guaranteed bandwidths exceeds
the bandwidth.
Set the value to be equal to or smaller than the bandwidth.
This list cannot be set to this port. This QoS flow list cannot be applied to this Ethernet interface.
To apply a QoS flow list to an Ethernet interface, the VLAN ID of a
flow detection condition in the QoS flow list must be included in the
settings of the Ethernet interface to which you want to apply the list.