Specifications

36 Error Messages Displayed When Editing the Configuration
649
36.1.10 Spanning Tree information
Table 36-10 Spanning Tree error messages
Message Description
Can not configure spanning-tree when
Ring Protocol is configured.
The Spanning Tree Protocol cannot be set because the Ring
Protocol functionality is set.
Cost is over 65535, please set up in 1 to
65535 or set pathcost method to long.
The value for cost is equal to or greater than 65535. Set the cost
value from 1 to 65535 or set long for pathcost method.
Maximum number of entries are already
defined. <STP_VLAN>
You are trying to add more than the allowable maximum number of
entries. Delete entries that are no longer needed, and then add the
entries.
Maximum number of MST instance are
already defined.
The number of MST instances has already reached the maximum
number. The maximum number of MST instances that can be set is
16.
Pathcost method is short, please set up
in 1 to 65535 or set pathcost method to
long.
short is set for pathcost method. Set the cost value from 1 to
65535 or set long for pathcost method.
Relations between l2protocol-tunnel stp
and spanning-tree configuration are
inconsistent.
The relations between the BPDU forwarding configuration and the
Spanning Tree configuration are inconsistent. When a BPDU
forwarding configuration is set, the Spanning Tree Protocol must be
stopped.
Relations between PVST+ and the
protocol-vlan or mac-vlan configuration
are inconsistent.
PVST+ and a protocol VLAN or a MAC VLAN cannot be set
concurrently.
Too many parameters (VLAN-range of
MST Instance <MSTI ID>).
The number of input parameters exceeds the maximum number
(200). Set a value equal to or smaller than the maximum number.
<MSTI ID>: MST instance ID
36.1.11 Ring Protocol information
Table 36-11 Ring Protocol error messages
Message Description
axrp-<Ring ID>: cannot configure this
command to channel-group port.
A ring port cannot be set for an interface that is participating in a port
channel.
<Ring ID>: Ring ID
axrp-<Ring ID>: Can't delete axrp
configuration referred by other.
The specified ring ID cannot be deleted because it is being used by
the axrp-ring-port command.
<Ring ID>: Ring ID
axrp-<Ring ID>: maximum number of
ring-id are already defined.
The maximum number of ring IDs that can be used in a Switch is 4. No
more than 4 ring IDs can be set.
To add a ring ID, you must first delete a registered ring ID.
<Ring ID>: Ring ID