Specifications

36 Error Messages Displayed When Editing the Configuration
648
Message Description
vlan[<VLAN ID>] : Can't delete vlan
configuration referred by other
configuration.
The VLAN cannot be deleted because it is being used by another
configuration.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : Can't set access-vlan
which is not configured to use vlan.
The access VLAN cannot be set because the VLAN does not exist.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : Can't set
mac-address-table static which is not
configured to use vlan.
mac-address-table cannot be set because the VLAN does not
exist.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : Can't set native-vlan
which is not configured to use vlan.
The native VLAN cannot be set because the VLAN does not exist.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : Data can't be set
because of not mac-based.
mac-address cannot be registered because the specified VLAN is
not a MAC VLAN.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : Data can't be set
because of not protocol-based.
protocol cannot be registered because the specified VLAN is not
a protocol VLAN.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : mac-address has
already been set to other VLAN[<VLAN
ID>].
The specified mac-address cannot be registered because it has
already been registered for another VLAN.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : maximum number
which can be used is exceeded.
No more entries can be generated because the number of VLANs
exceeds the maximum number of entries.
No more VLANs can be registered because the number of
registered mac-address items exceeds the maximum number of
entries.
No more entries can be registered because the number of
registered mac-address-table items exceeds the maximum
number of entries.
<VLAN ID>: VLAN ID
vlan[<VLAN ID>] : Protocol
{ethertype|llc|snap-ethertype} <HEX>
duplicate at ChGr[<Channel group#>].
Only one VLAN can be set per port channel/protocol value
combination.
<VLAN ID>: VLAN ID
<HEX>: Protocol value
<Channel group#>: Channel group number
vlan[<VLAN ID>] : Protocol
{ethertype|llc|snap-ethertype} <HEX>
duplicate at port[<IF#>].
Only one VLAN to be specified by the same protocol value can be
set on the same port.
<VLAN ID>: VLAN ID
<HEX>: Protocol value
<IF#>: Ethernet port number
vlan-protocol : Cannot delete protocol
referred by VLAN configuration.
The protocol cannot be deleted because protocol uses it.
vlan-protocol : maximum number which
can be used is exceeded.
A maximum of 16 protocol values (ethertype value, llc value,
and snap-ethertype value) are used in the entire Switch. No
more than 16 protocol values can be set.