Specifications

36 Error Messages Displayed When Editing the Configuration
643
Message Description
extended-authentication is in use. This setting cannot be changed because at least one of the following
is enabled:
 Authentication IPv4 access list
 IEEE 802.1X: Port-based authentication (dynamic)
 Web authentication: Fixed VLAN mode, dynamic VLAN mode,
or Web authentication IP address
 MAC-based authentication: Fixed VLAN mode or dynamic
VLAN mode
Delete the following:
 authentication arp-relay
 authentication ip access-group
 dot1x port-control
 web-authentication ip address
 web-authentication port
 mac-authentication port
filter is in use. This setting cannot be changed because the filter functionality is
enabled. Delete the setting of ip access-group and of mac
access-group.
igmp-snooping is in use. The setting cannot be changed because the IGMP snooping
functionality is enabled. Delete the setting of ip igmp snooping.
mld-snooping is in use. This setting cannot be changed because the MLD snooping
functionality is enabled. Delete the setting of ipv6 mld snooping.
qos is in use. The setting cannot be changed because the QoS functionality is
enabled. Delete the setting of ip qos-flow-group and of mac
qos-flow-group.
resource unavailable The total number of specified resources exceeds 7. Sets a value
equal to or smaller than 7.
36.1.5 Information about the power saving functionality
Table 36-5 Error messages related to the power saving functionality
Message Description
Can't execute. The command could not be executed. Re-execute the command.
Invalid time-range. An end date that is earlier than the start data is specified.
Revise the setting.
36.1.6 Ethernet information
Table 36-6 Ethernet error messages
Message Description
Cannot attach the interface specified as a
ring-port to the channel-group.
The interface set as a ring port cannot participate in the port
channel.
To allow the specified interface to participate in the port channel, first
delete the ring-related configuration.