Specifications

lldp hold-count
631
lldp hold-count
Sets the time that a neighboring device retains an LLDP frame sent from a Switch.
Syntax
To set or change information:
lldp hold-count <Count>
To delete information:
no lldp hold-count
Input mode
(config)
Parameters
<Count>
Sets the scaling for the value set by the
lldp interval-time command as the time
that a neighboring device retains the LLDP frame sent from a Switch. If the time
exceeds 65535, which is the maximum value, 65535 is used.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
2 to 10
Default behavior
4 is set as the time that a neighboring device retains LLDP frames sent from the Switch.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
lldp run