Specifications

logging host
624
logging host
Sets the output destination for log information. The command can configure up to 4 entries.
Syntax
To set or change information:
logging host <IP address>
To delete information:
no logging host <IP address>
Input mode
(config)
Parameters
<IP address>
Specifies the IPv4 address of the log output destination.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
<IP address>
Specifies the IPv4 address in dot notation.
1.0.0.0 to 126.255.255.255, 128.0.0.0 to 223.255.255.255
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. To use the syslog functionality, a syslog daemon program must be running on the
destination host and the host must be configured so that it can receive the syslog
information from the Switch.
2.
127.*.*.* cannot be set as an IPv4 address.
Related commands
None