Specifications

snmp-server contact
608
snmp-server contact
Sets the contact information of the Switch.
Syntax
To set or change information:
snmp-server contact <Text>
To delete information:
no snmp-server contact
Input mode
(config)
Parameters
<Text>
Sets the contact information for the Switch used when a failure occurs on the Switch.
This information can be referenced by using the name set in
[sysContact] of the
system group for inquiries from the SNMP manager.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify a character string that is no more than 60 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
Default behavior
The initial value is null.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. To reference information about name, contact, and location from the SNMP
manager, you must use the
snmp-server community command to register the
SNMP manager.
Related commands
None