Specifications

rmon event
605
Blank
2. Range of values:
Specify a character string that is no more than 79 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
owner <Owner string>
Sets the identification information of the person who specified this setting. This
information is used to identify the person who specified this setting. This parameter
is equivalent to
eventOwner defined in RFC 1757.
1. Default value when this parameter is omitted:
Blank
2. Range of values:
Specify a character string that is no more than 24 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. When an event group is accessed from the SNMP manager and traps are sent to the
SNMP manager, you must register the SNMP manager by using the
snmp-server
community and snmp-server host commands.
2. To send a trap to the SNMP manager, set the IP address of the SNMP manager and
rmon by using the snmp-server host command.
3. A trap is sent only if the community name used when the SNMP manager is
registered matches the community name of the event group.
4. As the value for
rising-event-index or falling-event-index of an alarm group,
set the information identification number that has been set for the corresponding
event group. If the values are different, no event is executed when an alarm is
generated.
Related commands
snmp-server host
rmon alarm