Specifications

rmon event
604
rmon event
Sets the control information for an RMON (RFC 1757) event group. This command can
configure a maximum of 16 entries.
Syntax
To set or change information:
rmon event <Event#> [log] [trap <Community>] [description <Description
string>
] [owner <Owner string>]
To delete information:
no rmon event <Event#>
Input mode
(config)
Parameters
<Event#>
Sets the control information for an RMON event group. This parameter is equivalent
to
eventIndex defined in RFC 1757.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535
log
This parameter specifies the method for generating an alarm (event) and generates
an alarm log. This parameter is equivalent to
eventType defined in RFC 1757.
1. Default value when this parameter is omitted:
An alarm log is not generated.
2. Range of values:
None
trap <Community>
This parameter sets the method for generating alarms and sends SNMP traps to the
community specified for <Community>. This parameter is equivalent to
eventCommunity defined in RFC 1757.
1. Default value when this parameter is omitted:
No traps are issued.
2. Range of values:
Sets
trap and the community name.
Specify a character string that is no more than 60 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
description <Description string>
Uses a character string to set the description of an event. Use this parameter as a
note regarding the event. This parameter is equivalent to
eventDescription
defined in RFC 1757.
1. Default value when this parameter is omitted: