Specifications

rmon collection history
602
rmon collection history
Configures the control information for the RMON (RFC 1757) Ethernet statistics history.
This command can configure a maximum of 32 entries.
Syntax
To set or change information:
rmon collection history controlEntry <Integer> [owner <Owner name>]
[buckets
<Bucket number>] [interval <Seconds>]
To delete information:
no rmon collection history controlEntry <Integer>
Input mode
(config-if)
Parameters
<Integer>
Sets the information identification number for the statistics history control information.
This parameter is equivalent to
historyControlIndex defined in RFC 1757.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535
owner <Owner name>
Sets the identification information of the person who specified this setting. This
information is used to identify the person who specified this setting. This parameter
is equivalent to
historyControlOwner defined in RFC 1757.
1. Default value when this parameter is omitted:
Blank
2. Range of values:
Specify a character string that is no more than 24 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
buckets <Bucket number>
Sets the number of history entries in which statistics information can be stored. This
parameter is equivalent to
historyControlBucketsRequested defined in RFC
1757.
1. Default value when this parameter is omitted:
50
2. Range of values:
1 to 65535
Note: If a value from 51 to 65535 is set for <Bucket number>, operation is the
same as if 50 had been set.
interval <Seconds>
Sets the time interval (in seconds) for collecting statistics information. This
parameter is equivalent to
historyControlInterval defined in RFC 1757.
1. Default value when this parameter is omitted: