Specifications

server
36
Notes
1. A maximum of four RADIUS servers can be specified for each group.
2.
127.*.*.* cannot be set as an IPv4 address.
3. The configuration of this command must meet both of the following conditions:
 The value in this command is the same as the value in the
radius-server
host command (the values of auth-port and acct-port are also the same).
 The
radius-server host command configuration is enabled (the key
parameter has been set or the
radius-server key command has been
configured).
4. If multiple RADIUS servers are configured in the same RADIUS server group, the
address displayed by using the
show radius-server operation command is the
primary RADIUS server in the RADIUS server group. This primary RADIUS server is
used as the first current server (the destination for RADIUS authentication requests).
The current server becomes the next RADIUS server in the primary RADIUS server
group.
Note that automatic restoration of the primary RADIUS server is governed by the
configuration of the
radius-server dead-interval command.
Related commands
aaa group server radius
dot1x authentication
mac-authentication authentication
radius-server host
web-authentication authentication
web-authentication user-group