Specifications

ethernet cfm mip
590
ethernet cfm mip
Sets a MIP used by the CFM functionality.
Syntax
To set information:
ethernet cfm mip level <Level>
To delete information:
no ethernet cfm mip level <Level>
Input mode
(config-if)
Parameters
level <Level>
Specifies the domain level that has been set by using the ethernet cfm domain
command.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 7
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the ethernet cfm mep command is set on the same interface, a domain level equal
to or lower than the
ethernet cfm mep command cannot be specified.
2. This command cannot be set for an Ethernet interface that is set for a channel group.
Also, an Ethernet interface set by using this command cannot be set for a channel
group. Set this command for the port channel interface to which the applicable
Ethernet interface belongs.
Related commands
ethernet cfm domain