Specifications

ethernet cfm mep
589
When direction-up has been set by using the ethernet cfm domain
command, Up MEP is used. If it has not been set, Down MEP is used.
2. Range of values:
down or up
3. Note on using this parameter:
This parameter cannot be changed. If you want to change this parameter,
delete this configuration first, and then reset it.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the ethernet cfm mip command is set on the same interface, a domain level equal
to or higher than the
ethernet cfm mip command cannot be specified.
2. This command cannot be set for an Ethernet interface that is set for a channel group.
Also, an Ethernet interface set by using this command cannot be set for a channel
group. Set this command for the port channel interface to which the applicable
Ethernet interface belongs.
Related commands
ethernet cfm domain