Specifications

ethernet cfm domain
584
ethernet cfm domain
Sets a domain. Executing this command switches to config-ether-cfm mode in which
the domain name and MA can be set.
Syntax
To set information:
ethernet cfm domain level <Level> [direction-up]
To delete information:
no ethernet cfm domain level <Level>
Input mode
(config)
Parameters
level <Level>
Sets the domain level.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 7
direction-up
When up/down is not explicitly set by using the
ethernet cfm mep command, you
can set this parameter to have the Switch operate in Up MEP mode.
1. Default value when this parameter is omitted:
The Switch operates in Down MEP mode.
2. Range of values:
None
3. Note on using this parameter:
This parameter cannot be changed. If you want to change the parameter,
delete the applicable command first, and then set the parameter.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If any of the following commands references a domain set by using this command,
this command cannot be deleted:
 ethernet cfm cc enable
 ethernet cfm mep