Specifications

ethernet cfm cc enable
580
ethernet cfm cc enable
Sets in a domain an MA in which the CC functionality is used.
If the
ethernet cfm mep command has already been set, the applicable port starts to send
CCMs.
Syntax
To set information:
ethernet cfm cc level <Level> ma <No.> enable
To delete information:
no ethernet cfm cc level <Level> ma <No.> enable
Input mode
(config)
Parameters
level <Level>
Specifies the domain level that has been set by using the ethernet cfm domain
command.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 7
ma <No.>
Specifies an MA ID number that has been set by using the ma name command or the
ma vlan-group command. Even if the ma name command is used to specify the MA
name, using a character string, or a VLAN ID, this parameter specifies the MA ID
number.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 65535
Default behavior
Monitoring by CC is not performed.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
ethernet cfm domain