Specifications

ethernet cfm cc alarm-reset-time
576
ethernet cfm cc alarm-reset-time
Sets the time interval for identifying re-detection when CC repeatedly detects failures. If a
failure is detected within the time set by using this command after a failure has been
detected, the failure is treated as a re-detection and no trap is sent.
Note, however, that if a failure with a failure level higher than the currently detected failure
level is detected, a trap is sent.
Syntax
To set or change information:
ethernet cfm cc level <Level> ma <No.> alarm-reset-time <Time>
To delete information:
no ethernet cfm cc level <Level> ma <No.> alarm-reset-time
Input mode
(config)
Parameters
level <Level>
Specifies the domain level that has been set by using the ethernet cfm domain
command.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 7
ma <No.>
Specifies an MA ID number that has been set by using the ma name command or the
ma vlan-group command. Even if the ma name command is used to specify the MA
name, using a character string, or a VLAN ID, this parameter specifies the MA ID
number.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 65535
alarm-reset-time <Time>
Sets the time for re-detecting a failure.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Multiples of 100 from 2500 to 10000 in milliseconds
Default behavior
The maximum time for treatment as a re-detection is 10000 milliseconds.
Impact on communication
None