Specifications

loop-detection interval-time
569
loop-detection interval-time
Sets the interval for sending L2 loop detection frames.
Syntax
To set or change information:
loop-detection interval-time <Seconds>
To delete information:
no loop-detection interval-time
Input mode
(config)
Parameters
<Seconds>
Sets the interval (in seconds) for sending L2 loop detection frames.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 3600 (seconds)
Default behavior
The interval for sending L2 loop detection frames is 10 seconds.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
loop-detection enable