Specifications

loop-detection auto-restore-time
566
loop-detection auto-restore-time
Sets the time required for automatic activation of a blocked port.
Syntax
To set or change information:
loop-detection auto-restore-time <Seconds>
To delete information:
no loop-detection auto-restore-time
Input mode
(config)
Parameters
<Seconds>
Sets the time (in seconds) required for automatic activation of a blocked port.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
60 to 86400 (seconds)
Default behavior
The blocked port is not activated automatically.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. When this command has been set and the parameter is changed, if time remains
until the port is activated automatically, the change becomes operational only after
the remaining time has been cleared.
Related commands
loop-detection enable