Specifications
storm-control
560
1. Default value when this parameter is omitted:
Operation log data is not output when a storm is detected.
filter-broadcast <Packet/s>
When the flow rate of broadcast frames has a limit, this parameter sets the limit value
(lower threshold) as the number of broadcast frames that can be forwarded. The
frames exceeding the flow rate limit value are discarded. If 0 is set, all applicable
frames are discarded.
1. Default value when this parameter is omitted:
When the flow rate has a limit, all broadcast frames are discarded.
2. Range of values:
0 to 10000000
filter-multicast <Packet/s>
When the flow rate of multicast frames has a limit, this parameter sets the limit value
(lower threshold) as the number of multicast frames that can be forwarded. The
frames exceeding the flow rate limit value are discarded. If 0 is set, all applicable
frames are discarded.
1. Default value when this parameter is omitted:
When the flow rate has a limit, all multicast frames are discarded.
2. Range of values:
0 to 10000000
filter-unicast <Packet/s>
When the flow rate of unknown unicast frames has a limit, this parameter sets the
limit value (lower threshold) as the number of unknown unicast frames that can be
forwarded. The frames exceeding the flow rate limit value (lower threshold) are
discarded. If 0 is set, all applicable frames are discarded.
1. Default value when this parameter is omitted:
When the flow rate has a limit, all unknown unicast frames are discarded.
2. Range of values:
0 to 10000000
filter-recovery-time <Seconds>
Sets the monitoring time for cancellation of the flow rate limit after flow rate limit has
gone into effect due to the detection of a storm. The monitoring time begins when the
number of received frames drops below the recovery-from-storm threshold, and the
flow rate limit is canceled when the time expires.
1. Default value when this parameter is omitted:
The initial value is 1 seconds.
2. Range of values:
1 to 30 (seconds)
Default behavior
None
Impact on communication
None