Specifications

efmoam udld-detection-count
556
efmoam udld-detection-count
Sets the number of OAMPDU response timeouts that must occur to recognize a failure.
(The OAMPDU is a monitoring packet of the IEEE 802.3ah/UDLD functionality.)
Syntax
To set or change information:
efmoam udld-detection-count <Count>
To delete information:
no efmoam udld-detection-count
Input mode
(config)
Parameters
<Count>
Sets the number of OAMPDU response timeouts that must occur to determine that a
line failure has occurred when timeouts occur repeatedly. When the occurrence
reaches the specified number of times, the applicable port is deactivated.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
3 to 300 (times)
Default behavior
30 is used as the number of times for determining a line failure.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If a value smaller than the initial value is set, a unidirectional link failure might be
falsely detected.
Related commands
None