Specifications

efmoam active
554
efmoam active
Sets the port to be monitored by the IEEE 802.3ah/OAM functionality to active mode.
Syntax
To set or change information:
efmoam active [udld]
To delete information:
no efmoam active
Input mode
(config-if)
Parameters
udld
Sets the applicable port as the port to be monitored by the IEEE 802.3ah/UDLD
functionality and enables the unidirectional link failure detection functionality.
1. Default value when this parameter is omitted:
The unidirectional link failure detection functionality is not executed on the
applicable port.
2. Range of values:
None
Default behavior
The applicable port operates in passive mode and does not detect a unidirectional link
failure.
Impact on communication
If this functionality is enabled and a line failure is detected, the applicable port is
deactivated.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the udld parameter is not set on both connected ports, link failures cannot be
detected by using this functionality.
Related commands
None