Specifications

switchport backup mac-address-table update exclude-vlan
549
switchport backup mac-address-table update exclude-vlan
Sets the VLAN to be excluded when sending MAC address update frames.
Syntax
To set or change information:
switchport backup mac-address-table update exclude-vlan <VLAN ID list>
To delete information:
no switchport backup mac-address-table update exclude-vlan
Input mode
(config-if)
Parameters
<VLAN ID list>
Sets the list of VLANs to be excluded when MAC address update frames are sent.
Entering a new value overwrites the existing information.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
For details about how to set <VLAN ID list> and the specifiable values, see
Specifiable values for parameters.
Default behavior
MAC address update frames are sent to all VLANs included on the primary port.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. You can set a maximum of 200 parameter values for excluding VLANs.
Example when four VLAN parameter values are set:
switchport backup mac-address-table update exclude-vlan 10-20,25-30
When a hyphen (-) is used in the VLAN list specification, the value before and the
value after the hyphen are counted as two values.
2. Setting the
switchport backup mac-address-table update transmit command
enables this command.
3. Set this command for the primary port.
Related commands
switchport backup interface
switchport backup mac-address-table update transmit