Specifications

mac-authentication static-vlan force-authorized
521
mac-authentication static-vlan force-authorized
When the RADIUS authentication method is used, this command forcibly changes the
status of a terminal that requests authentication on the applicable port to authentication
authorized if the RADIUS server does not respond or a request to the RADIUS server fails
because of a route failure or other problem.
Syntax
To set or change information:
mac-authentication static-vlan force-authorized [action trap]
To delete information:
no mac-authentication static-vlan force-authorized
Input mode
(config-if)
Parameters
[action trap]
When forced authentication is authorized, private traps are issued.
 Default value when this parameter is omitted:
Private traps are not issued if forced authentication is authorized.
 Range of values:
action trap
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the mac-authentication
system-auth-control command is set.
2. See Table 24-1 Configuration commands and MAC-based authentication modes for
the authentication mode in which the command's settings are operable.
3. Be especially careful when using this functionality, as it can pose a security problem.
4. This command is enabled when the following condition exists:
 All the following configurations have been set:
-
radius-server host or mac-authentication radius-server host
-
mac-authentication port
#1
-
mac-authentication static-vlan force-authorized
#1
- mac-authentication system-auth-control
- aaa authentication mac-authentication
#2