Specifications

mac-authentication port
513
mac-authentication port
Sets the authentication mode for ports.
Syntax
To set information:
mac-authentication port
To delete information:
no mac-authentication port
Input mode
(config-if)
Parameters
None
Default behavior
When MAC-based authentication is valid, the port operates in legacy mode.
Impact on communication
If a port subject to authentication is deleted by using this command, authentication is
canceled on all applicable ports.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the mac-authentication
system-auth-control command is set.
2. See Table 24-1 Configuration commands and MAC-based authentication modes for
the authentication mode in which the command's settings are operable.
3. This command cannot be set if the
system function command is set and
extended-authentication has not been set. (This command can be set if the
system function command has not been set.) [AX1250S] [AX1240S]
4. This command can be set only for Ethernet interfaces.
Related commands
mac-authentication system-auth-control
authentication ip access-group
authentication arp-relay