Specifications

mac-authentication interface
504
mac-authentication interface
Sets the applicable interface ports in MAC-based authentication legacy mode.
Syntax
To set or change information:
mac-authentication interface fastethernet <IF# list> [AX1250S] [AX1240S]
mac-authentication interface gigabitethernet <IF# list>
To delete information:
no mac-authentication interface fastethernet [AX1250S] [AX1240S]
no mac-authentication interface gigabitethernet
Input mode
(config)
Parameters
<IF# list>
Sets ports for MAC-based authentication.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
See Specifiable values for parameters.
Default behavior
MAC-based authentication legacy mode is not used.
Impact on communication
If an interface is deleted by using this command, the legacy mode authentication terminal
registered on the interface you have deleted is released.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the mac-authentication
system-auth-control command is set.
2. See Table 24-1 Configuration commands and MAC-based authentication modes for
the authentication mode in which the command's settings are operable.
3. If at least one of the following commands is set for a Switch, this command cannot be
set:

authentication multi-step

dot1x authentication

mac-authentication authentication

web-authentication authentication

web-authentication user-group