Specifications

service dhcp
485
service dhcp
Sets the interface on which a DHCP server is enabled. Only the interface specified by using
this command receives DHCP packets.
Syntax
To set or change information:
service dhcp vlan <VLAN ID>
To delete information:
no service dhcp vlan <VLAN ID>
Input mode
(config)
Parameters
vlan <VLAN ID>
Sets the VLAN ID of a VLAN for which an IPv4 address is set.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Sets the VLAN ID set by using the
interface vlan command for <VLAN ID>.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. A maximum of 32 interfaces can be set.
Related commands
interface vlan