Specifications

web-authentication vlan
471
web-authentication vlan
Sets the VLAN ID to dynamically switch after user authentication.
Unless this command is set, no VLANs can be switched after authentication.
Syntax
To set or change information:
web-authentication vlan <VLAN ID list>
To delete information:
no web-authentication vlan <VLAN ID list>
Input mode
(config)
Parameters
<VLAN ID list>
Sets the VLAN ID list of MAC VLANs that can be switched after user authentication.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
For details about how to set <VLAN ID list> and the specifiable values, see
Specifiable values for parameters. Note that the default VLAN (
VLAN ID = 1)
cannot be set.
Default behavior
No VLANs are switched after authentication.
Impact on communication
If a VLAN is deleted by using this command, users registered in the deleted VLAN are
logged out.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. All VLAN IDs you have set must be set for a MAC VLAN.
4. If at least one of the following commands is set for a Switch, this command cannot be
set:

authentication multi-step

dot1x authentication

mac-authentication authentication

web-authentication authentication