Specifications

web-authentication user-group
468
web-authentication user-group
Enables the user ID-based authentication method.
To handle IDs in the forms
[<User ID>] and [<Authentication method list name>], use the
at mark (
@) to separate the entered user IDs.
Syntax
To set information:
web-authentication user-group
To delete information:
no web-authentication user-group
Input mode
(config)
Parameters
None
Default behavior
Entered user IDs are not separated by an at mark (@).
Impact on communication
If a change is made, all authentications are canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. If at least one of the following commands is set for a Switch, this command cannot be
set:

dot1x authentication
 dot1x vlan dynamic enable
 dot1x vlan dynamic radius-vlan
 mac-authentication authentication

mac-authentication interface

mac-authentication vlan

web-authentication authentication
 web-authentication vlan
4. If the authentication method list name separated from entered user IDs does not
match the authentication method list name set by using the
aaa authentication
web-authentication command, the default settings of the Switch are used.