Specifications

web-authentication static-vlan force-authorized
459
web-authentication static-vlan force-authorized
When the RADIUS authentication method is used, this command forcibly changes the
status of a terminal that requests authentication on the applicable port to authentication
authorized if the RADIUS server does not respond or a request to the RADIUS server fails
because of a route failure or other problem.
Syntax
To set or change information:
web-authentication static-vlan force-authorized [action trap]
To delete information:
no web-authentication static-vlan force-authorized
Input mode
(config-if)
Parameters
[action trap]
When forced authentication is authorized, private traps are issued.
 Default value when this parameter is omitted:
Private traps are not issued if forced authentication is authorized.
 Range of values:
action trap
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. Be especially careful when using this functionality, as it can pose a security problem.
4. This command is enabled when the following condition exists:
 All the following configurations have been set:
-
radius-server host or web-authentication radius-server host
-
web-authentication port
#1
-
web-authentication static-vlan force-authorized
#1
- web-authentication system-auth-control
- aaa authentication web-authentication
#2