Specifications

web-authentication redirect-mode
453
web-authentication redirect-mode
Sets a protocol to display the Web authentication Login page when the URL redirect
functionality is enabled.
Syntax
To set or change information:
web-authentication redirect-mode {http | https}
To delete information:
no web-authentication redirect-mode
Input mode
(config)
Parameters
{http | https}
Sets a protocol to display the Web authentication Login page when the URL redirect
functionality is enabled.
 Default value when this parameter is omitted:
This parameter cannot be omitted.
 Range of values:
http: The Login page for http is displayed.
https: The Login page for https is displayed.
Default behavior
The Login page for https is displayed.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. This command is invalid if the
no web-authentication redirect enable
command is set.
Related commands
web-authentication system-auth-control
web-authentication port
web-authentication redirect enable