Specifications

web-authentication radius-server host
451
retransmit <Retries>
Specifies the number of times an authentication request is resent to the RADIUS
server.
1. Default value when this parameter is omitted:
The number of times set by using the
radius-server retransmit command
is used. If no value is set, the initial value is 3.
2. Range of values:
0 to 15 (times)
key <String>
Specifies the RADIUS key used for encryption or for authentication of
communication with the RADIUS server. The same RADIUS key must be set for the
client and the RADIUS server.
1. Default value when this parameter is omitted:
The RADIUS key set by using the
radius-server key command is used. If
no key is set, the RADIUS server is disabled.
2. Range of values:
Specify a character string that has no more than 64 characters. For details
about the characters that can be specified, see Any character string in
Specifiable values for parameters.
Default behavior
The RADIUS server settings registered by using the radius-server host command are
used.
If the
radius-server host command is not registered, user authentication is performed by
using the internal Web authentication database without using the RADIUS server.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. When this command is set, the setting information of the RADIUS server referenced
by Web authentication has precedence over the information set by using the
radius-server host command (the settings of the radius-server host command
are not applied). For details about the settings of the general-use RADIUS server
information and the Web authentication RADIUS server information, see the
Configuration Guide Vol. 2.
4. A maximum of four Web authentication RADIUS servers can be specified for each
Switch.
5.
127.*.*.* cannot be set as an IPv4 address.
6. If the
key parameter is omitted and the radius-server key command is not set, the
RADIUS server is disabled.
7. If multiple Web authentication RADIUS servers are configured, the address