Specifications

web-authentication radius-server dead-interval
449
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. If three or more Web authentication RADIUS servers are configured and another
Web authentication RADIUS server becomes the current server after the monitoring
timer starts, the monitoring timer is not reset and continues to run.
4. In general, when the monitoring timer has started, it does not reset until it expires.
However, as exceptions, it resets in the following cases:
 When
web-authentication dead-interval 0 is configured by using this
command
 When information about the Web authentication RADIUS server operating as
the current server is deleted by using the
web-authentication
radius-server host configuration command
 When the
clear radius-server operation command is executed
5. If the monitoring timer expires while the authentication sequence is being executed
on a terminal subject to authentication, restoration of the primary Web authentication
RADIUS server is not performed until the executed authentication sequence is
completed.
Related commands
aaa authentication web-authentication
web-authentication port
web-authentication system-auth-control
web-authentication radius-server host