Specifications

web-authentication logout polling retry-interval
439
web-authentication logout polling retry-interval
Sets the interval between retransmissions of monitoring frames that periodically monitor
the connection status of authenticated terminals when a no-response state is detected.
Syntax
To set or change information:
web-authentication logout polling retry-interval <Seconds>
To delete information:
no web-authentication logout polling retry-interval
Input mode
(config)
Parameters
<Seconds>
Sets the retransmission interval of monitoring frames.
 Default value when this parameter is omitted:
This parameter cannot be omitted.
 Range of values:
1 to 10 (seconds)
Default behavior
1 second is set as the retransmission interval of monitoring frames.
Impact on communication
None
When the change is applied
The setting takes effect from the next retransmission interval.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. If the link for a monitored terminal goes down before periodic monitoring by the
functionality that monitors the connection of authenticated terminals arrives, the
Switch stops monitoring the terminal and logs it out due to its link-down state.
4. When the maximum connection time set by using the
web-authentication
max-timer command expires, the Switch stops monitoring the applicable terminal
and logs it out.
5. If the number of retransmissions when a no-response state is detected is set to the
maximum, the number of monitoring frames increases proportionately with the
number of authenticated users, overloading the Switch.
Set the polling interval by using the following formula as a guide:
Polling condition: