Specifications

web-authentication logout polling interval
437
web-authentication logout polling interval
Specifies the polling interval of a monitoring frame that periodically monitors the connection
status of an authenticated terminal.
Syntax
To set or change information:
web-authentication logout polling interval <Seconds>
To delete information:
no web-authentication logout polling interval
Input mode
(config)
Parameters
<Seconds>
Sets the polling interval of monitoring frames.
 Default value when this parameter is omitted:
This parameter cannot be omitted.
 Range of values:
60 to 86400 (seconds)
Default behavior
Monitoring frames are sent every 300 seconds to an authenticated terminal only if the
automatic logout command (the
web-authentication logout polling enable
command) used with periodic monitoring has been set.
Impact on communication
None
When the change is applied
The setting takes effect from the next polling interval.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. If the link for a monitored terminal goes down before periodic monitoring by the
functionality that monitors the connection of authenticated terminals arrives, the
Switch stops monitoring the terminal and logs it out due to its link-down state.
4. When the maximum connection time set by using the
web-authentication
max-timer command expires, the Switch stops monitoring the applicable terminal
and logs it out.
5. The polling interval is the time between the receipt of ARP Reply from a target
authenticated terminal and the next polling monitoring.
6. If the number of retransmissions when a no-response state is detected is set to the
maximum, the number of monitoring frames increases proportionately with the