Specifications

web-authentication logout polling enable
435
web-authentication logout polling enable
The no web-authentication logout polling enable command disables the auto logout
functionality executed when periodic connection monitoring detects that an authenticated
terminal is not connected.
Syntax
To set information:
no web-authentication logout polling enable
To delete information:
web-authentication logout polling enable
Input mode
(config)
Parameters
None
Default behavior
The connection of authenticated terminals is monitored according to the following
conditions, and a terminal is automatically logged out if a no-connection state is detected.
 Polling interval
The interval set by using the
web-authentication logout polling interval
command. 300 seconds is set by default.
 Retransmission interval
The interval set by using the
web-authentication logout polling
retry-interval command. 1 second is set by default.
 Number of retransmissions
The number of retransmissions set by using the
web-authentication logout
polling count
command. Three retransmissions is set by default.
Impact on communication
When the no web-authentication logout polling enable command is set, connection
is not monitored periodically. As a result, a terminal is not logged out automatically even if it
is disconnected.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. If the link for a monitored terminal goes down before periodic monitoring by the
functionality that monitors the connection of authenticated terminals arrives, the
Switch stops monitoring the terminal and logs it out due to its link-down state.
4. When the specified maximum connection time (set by using the