Specifications

web-authentication jump-url

430

When the change is applied

The change is applied immediately after setting values are changed.

Notes

1. All Web authentication settings take effect when the web-authentication

system-auth-control command is set.

2. See Table 23-1 Configuration commands and Web authentication modes for the

authentication mode in which the command's settings are operable.

3. When the Authentication Success page is replaced by using the

set

web-authentication html-files operation command, write the tag of the URL

() to jump to after successful authentication and the settings of

this command in the Authentication Success page file (

loginOK.html) that is to be

replaced. By doing this, the page specified by the URL appears automatically after

successful authentication.

4. When fixed VLAN mode is used, setting the time required before jumping to the

specified URL is not necessary. Specify the value if you want to automatically display

the URL faster than the default setting.

5. When dynamic VLAN mode or legacy mode is used, the IP address of the

authentication terminal must be changed for switching from a pre-authentication

VLAN to a post-authentication VLAN. Therefore, set the time required before

jumping to the specified URL to approximately 20 to 30 seconds.

 If IP addresses have been distributed to unauthenticated terminals on the

internal DHCP server (default lease time: 10 seconds), the IP addresses are

obtained from the normal DHCP server for a post-authentication VLAN.

Accordingly, it might take approximately 20-30 seconds before a

post-authentication VLAN can communicate after the completion of

authentication.

Related commands

web-authentication system-auth-control

web-authentication port

web-authentication vlan