Specifications

web-authentication ip address
428
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. This command cannot be set if the
system function command is set and
extended-authentication has not been set. (This command can be set if the
system function command has not been set.) [AX1250S] [AX1240S]
4. Because the IP address set by using this command is used exclusively for Web
authentication access on a Switch, the IP address is not sent outside the Switch.
5. When this setting is used, an IP address must be set for the pre-authentication
VLAN.
6. To use the Web authentication IP address on a port in fixed VLAN mode or dynamic
VLAN mode, you must set
authentication arp-relay.
7. After this command is set or deleted, a user who is in the process of being
authenticated must log in again.
Related commands
web-authentication system-auth-control
web-authentication port
authentication arp-relay