Specifications

web-authentication force-authorized vlan
423
web-authentication force-authorized vlan
When the RADIUS authentication method is used, if the RADIUS server does not respond
or a request to a RADIUS server fails due to route failure, this command forcibly changes
the status of a terminal, that requests authentication on the applicable port, to
authentication authorized and assigns a post-authentication VLAN.
Syntax
To set or change information:
web-authentication force-authorized vlan <VLAN ID> [action trap]
To delete information:
no web-authentication force-authorized vlan
Input mode
(config-if)
Parameters
<VLAN ID>
Sets the post-authentication VLAN ID to be assigned when authentication is
permitted by forced authentication.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
See Specifiable values for parameters.
Note, however, that the default VLAN (
VLAN ID = 1) cannot be set.
[action trap]
When forced authentication is authorized, private traps are issued.
1. Default value when this parameter is omitted:
Private traps are not issued if forced authentication is authorized.
2. Range of values:
action trap
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.