Specifications

web-authentication authentication
420
web-authentication authentication
Sets the name of an authentication method list for the port-based authentication method.
Syntax
To set or change information:
web-authentication authentication <List name>
To delete information:
no web-authentication authentication
Input mode
(config-if)
Parameters
<List name>
Specify the authentication method list name set by using the
aaa authentication
web-authentication command.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify a character string that has no more than 32 characters. For details
about the characters that can be specified, see Specifiable values for
parameters (with the exception of the at mark (
@)).
We recommend that you use an upper-case letter for the first character.
Default behavior
Web authentication uses the default values of the Switch.
Impact on communication
Authentication of a terminal for a port whose authentication method list name has been
changed is canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the web-authentication
system-auth-control command is set.
2. See Table 23-1 Configuration commands and Web authentication modes for the
authentication mode in which the command's settings are operable.
3. If at least one of the following commands is set for a Switch, this command cannot be
set:
 dot1x vlan dynamic enable
 dot1x vlan dynamic radius-vlan
 web-authentication user-group
 web-authentication vlan
 mac-authentication interface