Specifications

dot1x vlan dynamic timeout tx-period
410
dot1x vlan dynamic timeout tx-period
Specifies the interval (in seconds) for sending EAP-Request/Identity packets when IEEE
802.1X authentication is valid.
Syntax
To set or change information:
dot1x vlan dynamic timeout tx-period <Seconds>
To delete information:
no dot1x vlan dynamic timeout tx-period
Input mode
(config)
Parameters
<Seconds>
Specifies the interval (in seconds) for sending EAP-Request/Identity packets.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535 (seconds)
Default behavior
30 seconds is used as the interval for sending EAP-Request/Identity packets.
Impact on communication
None
When the change is applied
 When the operating timer times out (the value of the timer becomes 0).
 When the
clear dot1x auth-state operation command is executed to cancel
authentication at the authentication level or the switch level.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x vlan dynamic enable command has
been set.
4. For the parameter, set a value smaller than the value set by using the
dot1x vlan
dynamic timeout reauth-period command.
Related commands
dot1x system-auth-control
dot1x vlan dynamic timeout reauth-period
dot1x vlan dynamic enable