Specifications

dot1x vlan dynamic timeout server-timeout
408
dot1x vlan dynamic timeout server-timeout
Specifies the time (in seconds) to wait for a response, including the time required for
retransmitting a response to an authentication server.
Syntax
To set or change information:
dot1x vlan dynamic timeout server-timeout <Seconds>
To delete information:
no dot1x vlan dynamic timeout server-timeout
Input mode
(config)
Parameters
<Seconds>
Specifies the time (in seconds) to wait for a response.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535 (seconds)
Default behavior
30 seconds is used as the time to wait for a response.
Impact on communication
None
When the change is applied
 When the operating timer times out (the value of the timer becomes 0).
 When authentication starts
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x vlan dynamic enable command has
been set.
Related commands
dot1x system-auth-control
dot1x vlan dynamic enable