Specifications

dot1x vlan dynamic timeout quiet-period
405
dot1x vlan dynamic timeout quiet-period
Specifies the period of time (in seconds) for maintaining the unauthenticated state on the
applicable interface after an IEEE 802.1X authentication failure. During this period, no
EAPOL packets are sent and received EAPOL packets are ignored. Also, no authentication
is performed.
Syntax
To set or change information:
dot1x vlan dynamic timeout quiet-period <Seconds>
To delete information:
no dot1x vlan dynamic timeout quiet-period
Input mode
(config)
Parameters
<Seconds>
Specifies the period of time (in seconds) for maintaining the unauthenticated state.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 65535 (seconds)
Default behavior
60 seconds is used as the period for maintaining the unauthenticated state.
Impact on communication
None
When the change is applied
When the Switch enters the unauthenticated state due to an authentication failure.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x vlan dynamic enable command has
been set.
Related commands
dot1x system-auth-control
dot1x vlan dynamic enable