Specifications

dot1x vlan dynamic supplicant-detection
403
dot1x vlan dynamic supplicant-detection
Specifies the behavior when a new terminal is detected.
Syntax
To set or change information:
dot1x vlan dynamic supplicant-detection {disable | shortcut}
To delete information:
no dot1x vlan dynamic supplicant-detection
Input mode
(config)
Parameters
{disable | shortcut}
Specifies the behavior when a new terminal is detected.
disable
If there is a terminal that was detected on the applicable port, this parameter
suppresses EAP-Request/Identity transmission processing for detecting a
new terminal. Specify this parameter if a supplicant operates abnormally if the
authentication sequence is omitted in order to decrease switch load.
If this parameter is specified, authentication processing for a supplicant for
which authentication cannot be initiated from the terminal cannot be started.
shortcut
Omits the authentication sequence of an authenticated terminal during
EAP-Request/Identity transmission for detecting a new terminal to reduce the
load. Specify this parameter for a supplicant that is unable to initiate
authentication from a terminal.
If this parameter is set, some supplicants do not operate correctly and
communication temporarily stops.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
None
Default behavior
shortcut is used as the operation when a new terminal is detected.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for