Specifications

dot1x vlan dynamic reauthentication
402
dot1x vlan dynamic reauthentication
Sets whether a supplicant is to be re-authenticated after successful IEEE 802.1X
authentication. When this command is in effect, EAP-Request/Identity packets for
re-authentication are sent to a supplicant at the interval set by using the
dot1x vlan
dynamic timeout reauth-period command as a prompt for supplicant re-authentication.
Syntax
To set information:
dot1x vlan dynamic reauthentication
To delete information:
no dot1x vlan dynamic reauthentication
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x vlan dynamic enable command has
been set.
4. If the
dot1x vlan dynamic ignore-eapol-start command has been set, you
cannot use the
no dot1x vlan dynamic reauthentication command to set no
re-authentication.
Related commands
dot1x system-auth-control
dot1x vlan dynamic ignore-eapol-start
dot1x vlan dynamic timeout reauth-period
dot1x vlan dynamic enable