Specifications

dot1x vlan dynamic radius-vlan
401
values, see Specifiable values for parameters. Note that the default VLAN
(VLAN ID = 1) cannot be specified for this command.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x vlan dynamic enable command has
been set.
4. The <VLAN ID list> parameter can be set only for the VLAN ID of a MAC VLAN that
has been set.
5. A maximum of 256 VLANs can be set for VLAN-based authentication (dynamic).
6. If one of the VLANs within the specified range cannot be set, an error occurs.
7. If at least one of the following commands is set for a Switch, this command cannot be
set:

authentication multi-step

dot1x authentication

mac-authentication authentication

web-authentication authentication

web-authentication user-group
Related commands
vlan
dot1x system-auth-control
dot1x vlan dynamic enable
switchport mac