Specifications

dot1x vlan dynamic ignore-eapol-start
398
dot1x vlan dynamic ignore-eapol-start
Sets the Switch not to issue EAP-Request/Identity packets in response to EAPOL-Start
from a supplicant.
Syntax
To set information:
dot1x vlan dynamic ignore-eapol-start
To delete information:
no dot1x vlan dynamic ignore-eapol-start
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x vlan dynamic enable command has
been set.
4. This command can be set only on an interface on which the
dot1x vlan dynamic
reauthentication command set and disable is not set for the dot1x vlan
dynamic supplicant-detection command.
5. This command cannot be set on an interface on which
disable is set for the dot1x
vlan dynamic supplicant-detection
command.
6. If this command has been set, you cannot use the
no dot1x vlan dynamic
reauthentication command to set no re-authentication.
Related commands
dot1x vlan dynamic reauthentication
dot1x vlan dynamic supplicant-detection
dot1x system-auth-control
dot1x vlan dynamic enable