Specifications

dot1x timeout supp-timeout
395
dot1x timeout supp-timeout
Specifies the time (in seconds) to wait for a response from a supplicant for an EAP-Request
packet sent to a supplicant. If no response is received during the specified period, the
EAP-Request packet is retransmitted.
Syntax
To set or change information:
dot1x timeout supp-timeout <Seconds>
To delete information:
no dot1x timeout supp-timeout
Input mode
(config-if)
Parameters
<Seconds>
Specifies the time (in seconds) to wait for a response from a supplicant.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535 (seconds)
Default behavior
30 seconds is used as the time to wait for a response from a supplicant.
Impact on communication
None
When the change is applied
 When the operating timer times out (the value of the timer becomes 0).
 When authentication starts
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x port-control command has been set.
Related commands
dot1x system-auth-control
dot1x max-req
dot1x port-control