Specifications

dot1x timeout keep-unauth
389
dot1x timeout keep-unauth
Sets the period of time (in seconds) for maintaining the communication-disabled state of
the interface if two or more terminals are connected to an interface on which the
single-mode authentication submode is set. After the time set by using this command
elapses, an authenticated terminal must be re-authenticated.
Syntax
To set or change information:
dot1x timeout keep-unauth <Seconds>
To delete information:
no dot1x timeout keep-unauth
Input mode
(config-if)
Parameters
<Seconds>
Sets the period of time (in seconds) for maintaining the communication-disabled
state when single mode is set as authentication submode.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535 (seconds)
Default behavior
3600 seconds is used as the period of time for maintaining the communication-disabled
state.
Impact on communication
None
When the change is applied
When the communication becomes impossible.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x port-control command has been set.
4. The value set for this command is applied only to an interface in single-mode
authentication submode.
Related commands
dot1x system-auth-control
dot1x port-control