Specifications

dot1x reauthentication
385
dot1x reauthentication
After successful IEEE 802.1X authentication, this command sets whether a supplicant is to
be re-authenticated. When this command is in effect,
EAP-Request/Identity packets for
re-authentication are sent at the interval set by using the
dot1x timeout reauth-period
command to a supplicant as a prompt for supplicant re-authentication.
Syntax
To set information:
dot1x reauthentication
To delete information:
no dot1x reauthentication
Input mode
(config-if)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x port-control command has been set.
4. If the
dot1x ignore-eapol-start command has been set, you cannot use the no
dot1x reauthentication command to set no re-authentication.
Related commands
dot1x ignore-eapol-start
dot1x timeout reauth-period
dot1x system-auth-control
dot1x port-control