Specifications

dot1x port-control
379
the authentication mode in which the command's settings are operable.
3. When port-based authentication (static) is used, set the following commands for the
same interface (these commands can be set for Ethernet interfaces and port channel
interfaces):
dot1x port-control auto
switchport mode access
switchport access
4. When port-based authentication (dynamic) is used, pay attention to the following:
This command cannot be set if the
system function command is set and
extended-authentication has not been set. (This command can be set if
the
system function command has not been set.) [AX1250S] [AX1240S]
Set the following commands for the same interface (these commands can be
set only for Ethernet interfaces):
-
dot1x port-control auto
-
switchport mode mac-vlan
5. When the
authentication ip access-group command or the authentication
arp-relay command has been set for the applicable port, this command can be
deleted if the following condition exists:
web-authentication port or mac-authentication port has been set.
6. If the
dot1x multiple-authentication command has not been set, the
authentication submode is single mode.
Related commands
dot1x system-auth-control
dot1x multiple-authentication
switchport mode
switchport access
switchport mac